HP ml310 Manual Do Utilizador

 

  CAUTION:  Heatsink retaining screws should be tightened in 

diagonally opposite pairs (in an "X" pattern). 

 

11.

 Connect the fan cable to the system board ("System board components" on 

page 

12.

 Install the access panel ("Installing the access panel" on page 

13.

 Install the bezel ("Unlocking the bezel" on page 

14.

 Power up the server ("Powering up the server" on page 

 

You can expand server memory by installing PC2-4200 DDR2 SDRAM DIMMs. 
The system supports up to four DIMMs for a maximum of 8 GB.  

Refer to "System board components (on page 

)" for DIMM slot locations and 

bank assignments. 

 

Observe the following guidelines when installing additional memory: 

•

  DIMMs installed in the server must be Unbuffered DDR2 DRAM with ECC. 

•

  If only a single DIMM is installed, it must be installed in slot 1A.