HP proliant dl580 Manual Do Utilizador
Removal and replacement procedures 20
1.
Power down the server (on page
2.
Use the T-15 Torx screwdriver to eject the drive, and pull the drive out of the server.
NOTE: The T-15 Torx screwdriver is shipped with the server and can be located on the rear panel ("
To replace the component, reverse the removal procedure.
Removing the processor module
NOTE: Refer the section "Processor module LEDs (on page
)" for information on the current processor
and PPM status.
1.
Power down the server (on page
2.
Remove the shipping bracket, if applicable.
NOTE: The shipping bracket is located near the processor module lever, and is marked with an orange tab
for easy identification.