Canon ir5570, ir6570 Manual
Chapter 3
3-23
3.1.2 E602 in Detail
0009-7924
iR5570 / iR6570
<E602-XXYY>
- XX= '00'
T-3-2
- XX= '01 to FF'
XX
YY
Description
Remedy
00
01
The HDD is not
recognized.
At start-up, the start-up
partition (BOOTDEV) is
not found.
1. Turn off the power, and check the HDD cable for
disconnection; then, turn the
power back on.
2. Turn on the power, and put your ear or finger
against the HDD to see if the disk inside it is rotating.
3. Replace the HDD.
4. Replace the main controller PCB.
02
The system software for
the main CPU is absent.
1. Start up in safe mode, and execute full formatting
using the SST; then, re-install
the system software, and turn off and then on the
power.
2. Replace the HDD.
03
An interrupt has been
detected during writing to
BootDevice.
1. Turn off the power, and turn it back on while
holding down the 1 and 9 keys.
See that the auto write interrupt sector repair routine
starts and the control panel goes
black.
2. See the progress of operation on the display (at the
start, the upper left cursor
will flash). When the display goes white, turn off and
then back on the power.
3. Start in safe mode, and execute full formatting
using the SST. Then, re-install
the system software, and turn off and then back on the
power.