Canon ir5570, ir6570 Handbuch

3-23

3.1.2 E602 in Detail

0009-7924

iR5570 / iR6570

- XX= '00'

T-3-2

- XX= '01 to FF'

The HDD is not 

recognized.

At start-up, the start-up 

partition (BOOTDEV) is 

not found.

1. Turn off the power, and check the HDD cable for 

disconnection; then, turn the 

power back on.

2. Turn on the power, and put your ear or finger 

against the HDD to see if the disk inside it is rotating.

3. Replace the HDD.

4. Replace the main controller PCB.

The system software for 

the main CPU is absent.

1. Start up in safe mode, and execute full formatting 

using the SST; then, re-install 

the system software, and turn off and then on the 

power.

2. Replace the HDD.

An interrupt has been 

detected during writing to 

BootDevice.

1. Turn off the power, and turn it back on while 

holding down the 1 and 9 keys. 

See that the auto write interrupt sector repair routine 

starts and the control panel goes 

black.

2. See the progress of operation on the display (at the 

start, the upper left cursor 

will flash). When the display goes white, turn off and 

then back on the power.

3. Start in safe mode, and execute full formatting 

using the SST. Then, re-install 

the system software, and turn off and then back on the 

power.