Sony LPR-1000MD Manual Do Utilizador

Mi
sc
el

la

ne
ou
s

Troubleshooting

53

Paper in the auto 
sheet feeder tray is 
not fed.

• The printer is not in print mode.

tCheck the status of the ON/

STANDBY and READY 
indicators, and turn both the ON/
STANDBY indicator and the 
READY indicator to green. 
(page 10)

• Paper is not loaded.

tLoad paper. (page 12)

• The paper guides (vertically and 

horizontally) are not correctly set. 
tSet them correctly. (page 12)

• Too much paper is loaded.

tDo not exceed the number of 

sheets which the automatic paper 
feed tray can hold. (page 11)

• Warped paper is being used.

tTry to make the warped paper lie 

flat and load it again. (page 12)

• Folded or wrinkled paper is being 

used.
tDo not use folded or wrinkled 

paper. (page 12)

• Paper is stacked improperly.

tRiffle the paper and load it again.

• The printer is not placed on a flat 

surface.
tPlace the printer on a flat surface. 

• An error message is displayed on the 

printer window display.
tTake remedies according to the 

message. (page 54)

The last sheet of 
paper cannot be fed.

It is often difficult to feed paper from 
the automatic paper feed tray, or 
sometimes it may be fed at an angle, 
depending on the circumstances.
tAdd one sheet of the same type of 

paper to the automatic paper feed 
tray and try to print again. (page 13)

The surface of 
printouts is dirty, 
especially the 
beginning of the 
printed surface.

The life span of the head cleaning roller 
may have run out.
tTry head cleaning two or three times 

and print a test page. If the printed 
surface is still dirty, replace the head 
cleaning roller. (page 46)

The printed surface is 
dirty.

• The paper path system may be dirty.

tOpen the top cover and wipe the 

plastic surface gently with a 
cotton swab to remove the dust.

Do not use alcohol.

• The life span of the head cleaning 

roller may have run out.
tTry head cleaning two or three 

times and print a test page. If the 
printed surface is still dirty, 
replace the head cleaning roller. 
(page 46)

• The ink of the printout just ejected is 

smeared on the ejected paper.
tThe next printout is ejected 

before the previous printout is 
dry and its printed surface may 
be dirty. In such a case remove 
the ejected printout one by one 
from the auto sheet feeder tray. 

The printout is 
smeared or smudged.

• Unsuitable paper is being used.

tUse suitable paper. If you use 

paper except other than that 
recommended, this may cause 
the ink to spray unevenly or run. 
(page 11)

• The amount of ink is excessive for 

the paper in use.
t The paper loaded in the auto 

sheet feeder tray is different from 
the media type specified in the 
Printing Preferences dialog box. 
Specify the correct media type. It 
is recommended to use the paper 
manufactured by Sony 
Corporation. (page 17)

The printout is blurry, 
or white stripes or 
scorches appear. Or 
there is a part which 
is not printed. 

The print head is dirty.
tTry head cleaning two or three times 

and print a test page. (pages 40 and 
42) If the printed surface is still 
dirty, consult your dealer.