Panasonic TY-CE42PS1 Manual Do Utilizador

4

English

Installation procedure

This ceiling unit weighs approx. 19kg (41.9lbs).

The display weights approx. 33kg (72.8lbs) to

45kg (99.2lbs). Refer to the diagram on the right

and confirm that the four points for mounting the

ceiling unit and display are capable of bearing

this weight. If the installation location is not

strong enough to bear this weight, reinforce the

ceiling before the ceiling unit and display are

installed.

300 (11

13

/

16

)

300 (11

13

/

16

)

350 (13

25

/

32

)

Ceiling installation holes

Front

24 (

15

/

16

)

14 (

35

/

64

)

R7

  (R

9

/

32

)

• Reinforce the ceiling if it is not strong enough.
• Use bolts appropriate for the ceiling material (not supplied).
• Refer to the  installing examples for wooden structure and concrete structure.

N o t e

3. Install the ceiling unit 

(upper section).

Flat washer 
(not supplied)

Spring washer 
(not supplied)
M12 bolt 
(not supplied)

Earthed mains extension lead
(example)

Signal cable 
(example)

1. Before installing the upper section, pull

the wiring through the pipe. Use an
earthed mains extension lead (not
supplied).

2. Make holes in the ceiling using a

method appropriate for the ceiling
structure and for inserting M12mm
bolts. Install the upper section using a
hex socket bolt (M12 not supplied), flat
washer and spring washer.

1. Check the strength of the installation location.

2. Prepare the ceiling unit.

Ceiling unit
(upper section)

M8 assembly screw

Ceiling unit 
(lower section)

• Remove the two M8 assembly screws

from the ceiling unit and separate the

upper and lower sections of the unit.

Units

: mm (in.)

M12 bolt

Spring washer

Flat washer

curled plug(M12)

Anchor nut or

Concrete

Installing to a concrete structure(example)

Installing to a wooden structure(example)

M12 bolt

Spring washer

Flat washer

Flat washer

Nut

Beam

" ] )

(min.thickness 40mm [1

9

/

16

 Mounting plate

Ceiling board

Nail