Panasonic WV-CP160 Manual Do Utilizador

Following explanation for installing the camera mounting bracket is for the installation on the
wall, but also applies equally to the installation on the ceiling, a shelf and stand.

1. Install the camera mounting bracket on

the wall with 2 screws.

The coaxial cable can be

passed through the center hole of
the camera mounting bracket.

2. Insert the camera fixing screw into the

camera mounting hole and tighten the
screw firmly.

Camera Mounting Bracket

Fixing Screws

The mounting bracket can be fixed either on the top or bottom cover of the camera.

Remove the mount adapter from the bot-
tom of the camera by removing the two fix-
ing screws. The mounting hole is a stan-
dard photographic pan-head screw size
(1/4” - 20). Attach the mount adapter to the
top as shown in the diagram, then mount
the camera on the mounting bracket.

Make sure that the two original fixing
screws are used when mounting the mount
adapter as longer length screws may dam-
age inner components.

3. Connect the camera and monitor with

the coaxial cable and turn on the
power switch of the monitor.

4. While viewing the monitor picture,

loosen the angular control screw slight-
ly. Adjust the camera’s angle to the
desired position, and then tighten the
screw firmly.

Angular Control Screw

Diam. 120
(Diam. 4-3/4)

90

°

15 (9/16)

85 (3-3/8)

40 (1-9/16)

5 (3/16)

6.5 (1/4)

164 (6-7/16)

2-Diam. 5 (2-Diam. 3/16)

83.5 (3-5/16)

Use wood screws with the cam-
era mounting bracket that are
suitable for Installation into a
wood base of appropriate
dimensions and strength. For
installation in a material other
than wood, refer servicing to
qualified service personnel.

Unit : mm (inch)

Fixing Screws

Mount Adaptor

Coaxial Cable

Fixing Screws

Camera Mounting
Bracket