BMW serie 3 sport wagon 2002 Manual Do Utilizador

134

Do not use spray starter fluids to start
the engine.

When your battery is discharged you can
used two jumper cables to start your
vehicle with power from the battery in a
second vehicle. You can also use the
same method to help start another
vehicle. Always use jumper cables with
fully insulated handles on the terminal
clamps.

Do not touch high-voltage wiring
and cables on a running engine.

Contact with components carrying high
voltage can be harmful or fatal. Care-
fully observe the following instructions
to avoid personal injury and/or damage
to one or both vehicles.

1. Ensure that the battery in the support

vehicle is also rated at 12 volts. This
information is provided on the top of
the battery casing

2. Do not disconnect your battery from

your vehicle's electrical system.
Switch off all electrical accessories in
both vehicles

3. Make absolutely certain that there is

no contact between the bodywork of
the two vehicles – short circuit
hazard

4. Start the engine on the support

vehicle and allow it to run

5. Use one jumper cable (+) to connect

the positive terminal of the battery in
the support vehicle with the auxiliary
positive terminal provided in the
engine compartment of your BMW
(arrow 1). The cover on this auxiliary
terminal is identified by a "+" symbol.
Remove by pulling the tab

6. Next, connect one end of the other

jumper cable (–) to either the support
vehicle's negative battery terminal or
a suitable ground on its engine or
bodywork. Connect the other end to
the negative battery terminal or a
suitable ground on the vehicle being
started. There is a special nut on
your BMW (2)

Always adhere to this sequence
when connecting jumper cables;

failure to observe this procedure can
lead to sparks at the battery terminals
and pose an injury hazard.

7. Start the support vehicle's engine

and let it run at an increased idling
speed for a few minutes. Start the
engine on the vehicle needing the
jump-start, and allow it to run as
usual. If the first start attempt is not
successful, wait a few minutes
before another attempt in order to
allow the discharged battery to
recharge

8. Before disconnecting the jumper

cables let the engines run for a few
minutes

9. Then disconnect the jumper cables

in reverse sequence.

Depending on the cause of the fault,
have the battery recharged by your
BMW center.

Jump-starting