BMW x5 2003 Manual Do Utilizador

Overview

Controls

Maintenance

Repairs

Data

Index

Starting the engine

Switching off the engine

Do not press the accelerator pedal
while starting the engine.

BMW X5 3.0i:
Do not actuate the starter for too

short a time. Do not turn it for more
than approx. 20 seconds. Release the
ignition key immediately as soon as the
engine starts.
BMW X5 4.4i, 4.6is:
Your BMW is equipped with the conve-
nience starting feature. Simply turn the
ignition key to position 3 – starter – and
then release it immediately.
The starter actuation continues to
operate automatically for a certain
period of time and is stopped automati-
cally as soon as the engine has started.
The automatic starting mode will not
operate if the battery voltage is low.
The engine can be started by means of
jump-starting, refer to page

162

Do not allow the engine to warm up
by leaving it running while the vehicle
remains stationary. Instead, begin to
drive immediately at a moderate engine
speed.

Should the engine fail to start on the
first attempt, if it is very hot or cold, for
instance:

Press the accelerator pedal halfway
down while engaging the starter.

Cold starts at altitudes above 3,300 ft/
1,000 meters and at very low tempera-
tures, from approx. +5 7/–15 6:

For the initial start attempt, allow the
starter to remain engaged somewhat
longer, approx. 10 seconds.

Engine idle speed is controlled by the
engine computer system. Increased
speeds at start-up are normal and
should decrease as the engine warms
up. If engine speed does not decrease,
service is required.

To prevent the battery from discharging,
always switch off electrical devices that
are not in use. Switch the ignition off
when the vehicle is not being driven.

Extended starting attempts, char-
acterized by excessively frequent

or long periods with the starter
engaged, can lead to damage of the
catalytic converter.

Turn the ignition key to position 1 or 0.

Do not remove the ignition key
while the vehicle is still moving. If

you do so, the steering will lock.
Always remove the ignition key and
engage the steering lock before leaving
the vehicle.
Vehicles with manual transmission:
Always engage the parking brake when
parking on slopes and inclined sur-
faces. Even placing the gearshift lever
in 1st gear or reverse may not provide
adequate resistance to rolling.
Vehicles with automatic transmission:
Place the selector lever in Park.

Vehicles with automatic transmission:

The vehicle must be stationary and the
selector lever in Park before you can
remove the ignition key.