This section describes the parameters used to configure the reverb effect that is applied to all of the
parts from each of your stage piano’s Performances. Settings for these parameters are made via
the Reverb screen, which contains two pages.

Edit Sequence

Press and hold the [REVERB] button (for at least one second)



Navigate to the

required page using the [

PAGE] and [PAGE

] buttons



Turn Knobs 1 to 3

Page

On-screen name

(and full name)

Description

RevType
(Reverb Type)

This parameter is used to select the type of reverb to be applied.
Setting values: RichHall, RichPlt, RichRoom, WoodRoom, Room1, Room2,

Stage1, or Stage2

RichHall (Rich Hall)

Emulation of hall acoustics with a rich, deep reverb sound.

RichPlt (Rich Plate)

Emulation of a rich, sustained plate reverb sound.

RichRoom
(Rich Room)

Emulation of room acoustics with a gentle reverb sound.

WoodRoom
(Woody Room)

Emulation of room acoustics with a warm reverb sound.

Room1

Emulation of room acoustics with a crisp reverb sound.

Room2

Emulation of room acoustics with a deeper reverb sound.

Stage1

Emulation of stage acoustics with a wide, sustained reverb
sound.

Stage2

Emulation of the reverb typical of a smaller stage.

RevTime
(Reverb Time)

This parameter is used to set how long it takes in seconds for the reverb sound to
fade to silence.
Setting values: WoodRoom ......................0.3s to 10.0s

Other reverb types...........0.3s to 30.0s

HPF (High-pass
Filter Cutoff)

This parameter is used to set the cutoff frequency for the Reverb block's high-pass
filter.
Setting values: 20Hz to 8.0kHz

FBHiDamp
(Feedback High
Damping)

This parameter is used to adjust the brightness’ of the reverb sound. At higher set-
tings, it takes longer for the high-frequency component to decay, producing a
brighter overall reverb sound. This parameter is not displayed on-screen when
RevType has been set to “WoodRoom”.
Setting values: 0.1 to 1.0