Manualsbrain.com
  1. Manuais
  2. Marcas
  3. Siemens
  4. TC63
  5. Manual Do Utilizador

Siemens TC63 Manual Do Utilizador

Download
Página de 501
TC63 AT Command Set  
10.1 AT^SICS
s
TC63_ATC_V00.490
Page 239 of 501
5/24/05
Confidential / Draft - Do not copy
 
uses dynamic DNS assignment. Any other address means that the Primary
DNS is manually set.
The default value applies automatically if no other address is set. Note that the
 read command only returns a manually configured IP address, while
the value "0.0.0.0" is not indicated at all, no matter whether assumed by default
or explicitly specified. 
“dns2“
Secondary DNS server address (IP address in dotted-four-byte format).
If "dns1" = "0.0.0.0" this setting will be ignored. Otherwise this value can be
used to manually configure an alternate server for the DNS1. 
If "dns1" is not equal "0.0.0.0" and no "dns2" address is given, then
"dns2"="0.0.0.0" will be assumed automatically. The 
 read command
only returns a manually configured IP address, while the value "0.0.0.0" is not
indicated at all, no matter whether assumed by default or explicitly specified. 
Parameter value; type and supported content depend on related 
Supported connection type values in 
 for 
 value "conType". 
“CSD“
Circuit-switched data call. 
“GPRS0“
GPRS connection. 
Settings of GPRS related commands are not used, e.g. 
. When a
service based on a GPRS connection profile is started after entering 
TC63 automatically tries to attach to the GPRS. Yet, the only exception is
 which can be used any time to detach from the GPRS and, and thus
disconnect the bearer opened with 
. 
“none“
Clears the connection profile. 
Character set selectable with 
 value "alphabet". 
[“0“]
Character set determined with 
 applies. 
“1“
International Reference Alphabet (IRA, seven bit ASCII) applies. 
Supported data rate values in 
 value "dataRate". 
“0“
14.4 KBaud 
[“1“]
9.6 KBaud 
Supported data call type values in 
 value "dataType". 
“0“
ISDN 
[“1“]
Analog 
<conParmValue>
(str)
<conParmValue-conType>
(str)
<conParmValue-alphabet>
(str)
<conParmValue-dataRate>
(str)
<conParmValue-dataType>
(str)