Sanyo POA-MD13NET2 Manual Do Utilizador

Use of Telnet

You can control the equipment connected to the serial port on the Network Board
and the projector itself by using the telnet application*

1

installed on your computer.

The following is a control example of external equipment. The telnet application is
needed to use commands*

2

which controls the external equipment.

Preparation

Turn the projector off with the mains switch and connect an external equipment to
the serial port with an RS-232C serial cable.

Turn on the projector and external equipment.

Display the setting page by clicking on Serial Port on the main menu with the web
browser. (

☞ p.62)

Change the serial port setting to be the same communication condition as the con-
nected external equipment and then click Set button.

The following example setting is for our projector
communication condition. When controlling our pro-
jector set as follows

:

Control

(For example, in case of using the Telnet application of the Windows XP Professional.)

Select Run... submenu from Start menu on the computer. Type “telnet” onto the
Open text area on the displayed window and press OK button.

The telnet application will start and the following window will be displayed. Type as
below to connect the projector.

> open 192.168.1.201 return

* Use the IP

address assigned
to the projector

Baud rate ..........19200
Parity ................NONE
Stop ..................1
Flow Control ......NONE
Data ..................8
Serial Control ....External
Port ..................23