Alliance Laundry Systems 25 pound capacity Manual Do Utilizador

70400001

18

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

1. Set DIP switch #8 to the ON position.

2. Select the desired program number to change. 

The LED should be flashing.

3. Select DRY TIME. Set the time with the Up/

Down arrows.

4. Select COOL TIME. Set the time with the Up/

Down arrows.

5. Select TEMPERATURE. Set the temperature 

with the Up/Down arrows.

6. Press and hold the Program Select button about 

3 seconds until the LED stops flashing. The 
selected program number is now programmed. If 
the Program button is pressed for less than 
3 seconds, the controller will cancel the program 
and display the next program’s settings. If not 
programmed correctly, the display will flash 
“E2F” for 4 seconds, and the default settings will 
be used. Follow steps 4 through 7 to reprogram 
any program number. When finished, set DIP 
switch #8 to OFF. The programs are now stored. 

7. During the Program Mode, if the Up/Down 

arrows or Display button is not pressed within 
10 seconds, the default program settings will be 
used.

8. Temporary Reprogramming of Current Programs 

(OPL ONLY)

9. The Drying Time, Cooling Time and 

Temperature of a program currently in use may 
be modified simply by adjusting any or all of the 
program parameters for that program, as needed. 
Once a modification has been made, the current 
program LED will flash indicating that it has 
been modified.

10. Use the Up/Down arrows to adjust program time.

11. Use the Display Select button to choose between 

Drying Time, Cooling Time, and Temperature. 
Then use the Up/Down arrows to adjust the times 
and temperature.

12. To cancel this temporary programming mode 

push the STOP button once to stop the current 
cycle and once more to cancel the modified 
program settings. The program will revert back to 
its original settings. 

The rotation sensor must “read” the key on the basket 
shaft or pulley. The sensor must be set approximately 
1/4 inch from the key or pulley. Look for the light on 
the sensor to come on as the key passes the sensor; this 
is a correctly operating sensor. If no light appears, 
either the sensor is out of range or the key/pulley or the 
sensor is bad. In addition, if the light stays on 
continuously, then the sensor is too close to the 
component or the sensor is bad. 

At the end of the cool down cycle, the tumbler will 
stop and display “END.” The DMP control will 
automatically rotate the basket for 5 seconds every 
2 minutes for a total of 20 minutes, until some 
function of the tumbler is activated/deactivated by the 
user. 

1. “dor” indicates that the loading or lint door is 

open.

2. Cycle the tumbler to check if the buzzer activates.

3. “P-F” indicates that the thermistor is short 

circuited or open circuited.

4. “bbt” indicates a broken belt condition or a faulty 

rotation sensor. (Only available on tumblers with 
the rotation sensor.)

5. Hold the START button to display the drum 

RPM’s; the display will read “r##” where ## are 
the RPM’s. (Only available on tumblers with the 
rotation sensor.)