Polycom RMX 2000 Manual Do Utilizador

A single supply unit powers the RMX 2000. Use the following procedure 

to replace a Power Supply:
1

Ensure that power switch to the RMX 2000 is turned OFF (O).

Unscrew the screws on the front panel of the RMX 2000 that secure 

the Power Supply.

Use the metal ejectors to pull the Power Supply Module out of its slot 

in the Backplane.

Carefully slide the Power Supply Module out through the front 

panel.

Slide in the replacement Power Supply Module.

Push the Power Supply Module firmly into the Backplane, making 

sure it is properly seated in its slot.

Ensure that the metal ejectors are fully retracted into their housings.

Tighten the screws on the front panel of the RMX 2000 that secure the 

Power Supply Module.

Turn ON the RMX 2000.