Polycom RMX 2000 Manual Do Utilizador

The RTM IP board on the rear of the RMX 2000 provides connectivity to 

all the MCU modules. Use the following procedure to replace the RTM IP 

board:
1

Ensure that power switch to the RMX 2000 is turned OFF (O).

Unscrew the screws on the rear panel of the RMX 2000 that secure the 

RTM IP board.

Use the metal ejectors to pull the RTM IP board out of its slot in the 

Backplane.

Carefully slide the RTM IP board out through the rear panel.

Slide in the replacement RTM IP board.

Push the RTM IP board firmly into the Backplane, making sure it is 

properly seated in its slots.

Ensure that the metal ejectors are fully retracted into their housings.

Tighten the screws on the rear panel of the RMX 2000 that secure the 

RTM IP board.

Turn ON the RMX 2000.