Directed Electronics rk20 Manual Do Utilizador

2-5 Activation Pulse One: This allows the system to use 1, 2 or 3 pulses to

activate the remote start sequence. The default setting is 1-pulse.

Note: This setting affects both the input wire and the remote control.

2-6 2nd—IGNITION/ACCESSORY OUTPUT: This will allow the PINK/WHITE

to be used as a 2nd ignition or a 2nd accessory.

2-7 Accessory State During Wait-To-Start OFF: This feature will allow the se-

lection of the accessory output to be ON or OFF during wait-to-start. Use the

two-honk setting for On.

2-8 2nd STATUS OUTPUT—NORMAL/LATCHED/PULSED: If programmed to

status mode, this output will turn on when the remote engine start is activated. In

this mode the output can be programmed to a latched or a pulsed output. The

pulsed output turns the defogger ON. When programmed to the latched output

the status will only stay active for 10 minutes. Both outputs activate 10 seconds

after remote engine start.

2-9 Anti-Grind On: With the anti-grind On (default) the ground-when-locked

output will be active during remote start operation. This activates the optional

starter kill relay and prevents the customer from re-cranking the car with the key,

when doing key takeover. If accessories such as a voice module or window

module are added to the unit, it may be necessary to use the two-honk setting

to program this feature OFF.

2-10 Diesel Timer—Wait-To-Start Input - Timed 0,15, 30, 45 SECONDS:

Default is 0 second delay. Also available is a delay of 15 (2), 30 (3), or 45(4)

seconds. This feature can also be optionally programmed with the ProSecurity

Programmer, with a delay from 1 to 90 seconds.