Philips lx7500r-01 Manual Do Utilizador
Problem
Solution
No sound
– Disconnect the headphones.
– Switch on the selected source or select another source.
– Switch on the selected source or select another source.
No picture, only sound is available
– Set the TV to the correct video channel for the selected source.
In a Scart chain: Problems seeing/hearing – Switch any other equipment in the Scart chain to standby.
the correct video source
the correct video source
If that does not help, also switch the equipment you want to see/hear to
standby. Next, switch it on again.
standby. Next, switch it on again.
Poor quality of playback: distorted
– Make sure the TV set is properly adjusted.
picture and/or sound
– Make sure the disc is not dirty. Clean the disc.
– Sometimes the picture may be temporarily distorted.This is not a defect of
– Sometimes the picture may be temporarily distorted.This is not a defect of
your DVD recorder system.
The picture is distorted or
– The TV system of the inserted disc does not match the TV system of your TV
black-and-white during playback
(PAL/NTSC).
– Select RGB + CVBS in the the system menu. See t Picture
➜
Video
output on page 47.
Picture and/or sound interference
– Check your aerial.
on TV reception
– Change the TV system (see “TV system” on page 52)
No bass sound
– Connect the supplied subwoofer.
No sound on one of the speakers
– Check if the speaker is connected properly.
– Check if the speaker cable is damaged.
– Check if the speaker cable is damaged.
No sound on the centre
– Press SURR repeatedly to select another surround effect.
and/or rear speakers
– Make sure you have connected all speakers.
– Make sure you have selected Yes for Centre connected and Rear
– Make sure you have selected Yes for Centre connected and Rear
connected in the menu Installation
➜
Audio setup
➜
Speaker setup.
See “Speaker setup” on page 55.
No digital surround sound
– Check if the inserted disc or the selected appliance supports digital
(Dolby Digital, DTS) available
surround sound.
– Check if the selected external equipment is connected to IN DIGITAL or
IN OPTICAL on the DVD recorder system.
No digital sound from equipment
– Switch the digital output of the connected equipment to PCM.
connected to IN DIGITAL or
IN OPTICAL
IN OPTICAL
No sound signal at the digital output
– Check if the setting for the digital output is correct. See “Digital output
setting” on page 55.
Distorted picture (“artifacts”)
– Switch the DVD recorder system from Progressive Scan to Interlaced
when playing a copyprotected DVD and
(see “Component video output” on page 47) or
using Progressive Scan
use the Scart connection.
Troubleshooting
61
English