Interphase Tech ispan 5535 pri Manual Do Utilizador
Connecting the Adapter to an MVIP Bus
16
Interphase Corporation
How to Configure MVIP Electrical Termination
on the
on the
iSPAN-PRI
The factory default configuration for the iSPAN-PRI adapter
does not require jumpers.
does not require jumpers.
If the adapter does not have to be electrically terminated, do
not insert any jumpers into the 2-pin connectors.
not insert any jumpers into the 2-pin connectors.
If this is the last board in a multiple MVIP bus configuration,
the iSPAN-PRI adapter requires electrical termination in the
MVIP bus. To provide the required electrical termination,
place two jumpers on the two 2-pin connectors located next to
the MVIP connector, as described in the following figure.
the iSPAN-PRI adapter requires electrical termination in the
MVIP bus. To provide the required electrical termination,
place two jumpers on the two 2-pin connectors located next to
the MVIP connector, as described in the following figure.
Figure 2-5. Electrically Terminating the MVIP Bus.