MINOLTA magicolor 2 Manual Do Utilizador
Control Panel
Problems
QMS magicolor 2 Op
eration
8-22
Control Panel Problems
Data Indicator Stays Lit
If the printer has warmed up and the Data indicator stays on, two
problems may exist. If you are downloading additional typefaces, too
many can overload the printer’s memory, causing the printer to reset
and lose information previously downloaded to RAM. Make sure you
have enough printer memory.
problems may exist. If you are downloading additional typefaces, too
many can overload the printer’s memory, causing the printer to reset
and lose information previously downloaded to RAM. Make sure you
have enough printer memory.
On a LocalTalk network, Macintosh computers sometimes interfere
with each other. If this happens often, reinstall the LaserWriter and
Laser Prep files, which reset the printer. If neither of these is the prob-
lem, place a service call to your QMS vendor.
with each other. If this happens often, reinstall the LaserWriter and
Laser Prep files, which reset the printer. If neither of these is the prob-
lem, place a service call to your QMS vendor.
No Advanced Status Page
If your printer prints a standard status page even though you’ve con-
figured the printer in the Administration/Special Pages/Status Page Type menu to print an advanced status page, your printer probably
doesn’t have enough free memory available. To print an advanced
status page you may need to reduce the amount of memory assigned
to one or more of the memory clients or add more memory (see the
“Memory” section in chapter 5, “Additional Technical Information,” in the
figured the printer in the Administration/Special Pages/Status Page Type menu to print an advanced status page, your printer probably
doesn’t have enough free memory available. To print an advanced
status page you may need to reduce the amount of memory assigned
to one or more of the memory clients or add more memory (see the
“Memory” section in chapter 5, “Additional Technical Information,” in the
Reference manual for information about memory clients).
No Start-up Page
If the Ready indicator is on, but no start-up page prints, check the fol-
lowing:
lowing:
1
Has the start-up page been disabled?
Use the control panel to make sure the start-up page is enabled.
2
Did you wait long enough? From a cold start, the printer
takes approximately 3 minutes to warm up.
takes approximately 3 minutes to warm up.
Be sure you wait long enough for a start-up page before suspect-
ing a problem.
ing a problem.