Viper 5002 Manual Do Utilizador

©

2006 

Directed Electronics, Inc.

W

Wiirriinngg  D

Diiaaggrraam

m  H

H,,  ((--))  N

Neeggaattiivvee  M

Muullttiipplleexx

To determine the resistor values, the door lock switch/key cylinder must be isolated from the factory

door lock system. For testing, use a calibrated digital multimeter that is set to ohms.

1.

Cut the output wire from the door lock switch/key cylinder in half. 

2.

Test with the meter from the switch side of the cut door lock switch/key cylinder wire to a

reliable ground source. Some good ground references are the ground input source to the door

lock switch/key cylinder or battery ground.

3.

Operate the door lock switch/key cylinder in both directions to determine the resistor values. 

If the multimeter displays zero resistance in one direction, no resistor is needed for that

direction.

4.

Once the resistor value(s) is determined, refer to the wiring diagram for proper wiring.