Viper 5002 Manual Do Utilizador
©
2006
Directed Electronics
17
Immobilizer Wire Connection Guide
Immobilizer Wiring Diagram
___
___
___
Immobilizer Wiring Guide
The starter immobilizer harness can be installed as a normally open or normally closed circuit by
connecting the desired side of the three-wire immobilizer. Locate the starter wire, then cut it and
make connections as described in the following diagram. Connect wire C to the end of the wire that
is still connected to the ignition switch; connect A or B wire to the end of the wire that continues
to the vehicle’s starter circuit.
connecting the desired side of the three-wire immobilizer. Locate the starter wire, then cut it and
make connections as described in the following diagram. Connect wire C to the end of the wire that
is still connected to the ignition switch; connect A or B wire to the end of the wire that continues
to the vehicle’s starter circuit.
Note: Factory default setting is normally closed, if wired for normally open you must change the
programming.
programming.
ON BOARD
IMMOBILIZER
NORMALLY OPEN (87)
NOT USED (87A)
COMMON (30)
NORMALLY
OPEN
GREEN/WHITE
GREEN
NORMALLY
CLOSED
ON BOARD
IMMOBILIZER
NOT USED (87)
NORMALLY CLOSED (87A)
COMMON (30)
GREEN/BLACK
GREEN/WHITE
GREEN/WHITE
Starter - Common (key side)
GREEN
Starter - Normally Open (motor side)
GREEN/BLACK
Starter - Normally Closed (motor side)
A
B
C