Microtek gnc m vx2 0506 Manual Do Utilizador

Select the image bar to adjust the synchronization and tracking of the analog

signal from the computer.  Click the “Image” icon under the OSD menu, and

select the “Synchronization” or “Tracking” bars in the “Image” box.  You may make

adjustments by revising the settings for the Synchronization and Tracking,

respectively.

If there is still some noise on the image after utilizing Auto Config. to adjust

the settings of Synchronization and Tracking, you may click “Synchroniza-

tion” to diminish it.

If the image remains blurred or presents vertical lines on it, you may click

“Tracking” to adjust for a pure image.

Enter the “Auto Config” icon under OSD menu, and the projector will automatically

select the frequency and image position for the analog signal.

Enter the “Information” icon under OSD menu, and the projector will present the

state of the image: current resolution (800*600 or 720*240), H

f 

(horizontal scan-

ning frequency)

 

& V

f 

(vertical scanning frequency) and lamp age (the consumed

hours).

Enter the “Miscellaneous” icon under OSD menu, you can restore the revised

settings to the defaults.  You may also make adjustments for OSD Timeout, OSD

Position, Dithering, Native Mode and Auto Color.

In the Miscellaneous box can also be found the “Factory Reset”, “OSD Timeout”,

“OSD Position”, “Dithering”, “Native Mode”, ”Color Temperature” and “Auto Color”

bars.

Select the “Factory Reset” bar, and all the settings you have revised will be

restored to the projector’s factory defaults.

Select the “OSD Timeout” bar, and the duration of OSD box displayed on the

image can be adjusted from 5 seconds to 60 seconds; i.e., the time of the

OSD box displayed on the image will last for min. 5 seconds to max. 60

seconds. (The duration will be extended by 5 seconds.)

Select the “OSD Position” bar, and you may adjust the position of the OSD

box on the image.

ＶＸ２．ｐ６５

02-10-18, 11:05

35