ONKYO CR-N1 Manual Do Utilizador

Getting connected

(The 75/300 ohm antenna adapter is not
included with the U.S., Canadian, and Euro-
pean models.)

The 75/300 ohm antenna adapter can be
used to connect an FM antenna with 300
ohm flat twin-core cable, or to connect an
FM antenna with a 75 ohm coaxial cable
with no connector attached.

Connecting 300 ohm flat twin-core
cable

1. Undo the two adapter screws, wrap the

bare wires around the screws, and then
retighten the screws, as shown.

2. Plug the 75/300 ohm adapter into the

CR-N1’s FM 75

Ω connector.

Connecting 75 ohm coaxial cable

1. Using a small screwdriver or your

fingernails, push the tabs outwards and
remove the adapter’s cover, as shown.

2. Move the wire inside the adapter from

position A to position B, as shown.

3. Prepare the end of the 75 ohm coaxial

cable and place it in the adapter, as
shown.

4. Push the center conductor between the

lugs as shown (1), and use a pair of
pliers to clamp the braided wire section
of the cable to the adapter (2).

Make sure that the braided wires are not
shorting to the center conductor.

Using the 75/300 ohm FM
antenna adapter

Outdoor
antenna

Indoor
antenna

300 ohm flat
twin-core cable

Position B

Position A

Wire

✦ ✦

✦

✦ ✦

✦

15 mm