ONKYO CR-N1 Manual Do Utilizador
59
Troubleshooting
Severe electrical interference may render the CR-N1’s microcomputer temporarily inoperable.
In this case you should unplug the CR-N1 for at least five seconds, and then reconnect it.
In this case you should unplug the CR-N1 for at least five seconds, and then reconnect it.
FM reception is hindered by
hiss and the tuning and stereo
indicators are flashing.
hiss and the tuning and stereo
indicators are flashing.
The received signal is too
weak?
weak?
Stereo FM transmissions travel
only half the distance of
regular transmissions?
only half the distance of
regular transmissions?
Try changing the position and
direction of the outdoor antenna.
direction of the outdoor antenna.
The radio presets no longer
work.
work.
The AC power cord has not
been connected to a wall
outlet for an extended
period?
been connected to a wall
outlet for an extended
period?
The AC power cord must be plugged
into a wall outlet a few times each
month in order to preserve the radio
presets and other settings.
Reprogram the presets. See page 42.
into a wall outlet a few times each
month in order to preserve the radio
presets and other settings.
Reprogram the presets. See page 42.
RDS doesn’t work.
The tuned station does not
support RDS?
support RDS?
Tune into an FM station that
supports RDS.
supports RDS.
The signal is too weak?
Try changing the position and
direction of the outdoor FM
antenna.
direction of the outdoor FM
antenna.
There’s too much
interference?
interference?
CD playback skips.
The CR-N1 is exposed to
vibration?
vibration?
Place the CR-N1 somewhere free
from vibration.
from vibration.
The disc is badly scratched?
Replace with a new disc.
The disc is very dirty?
Clean the disc.
Tracks cannot be memorized
with Memory Playback.
with Memory Playback.
No disc is loaded?
The CD doesn’t contain the
track number you are trying
to memorize?
track number you are trying
to memorize?
Memorize only available track
numbers.
numbers.
A disc is loaded, but playback
cannot be started.
cannot be started.
The disc is loaded the wrong
way round?
way round?
Load the disc with the labeled side
facing forwards. See page 35.
facing forwards. See page 35.
The disc is very dirty?
Clean the disc.
Condensation has formed
inside the CR-N1?
inside the CR-N1?
Unload the disc and leave the CR-N1
for several hours until the
condensation has cleared.
for several hours until the
condensation has cleared.
It takes a long time to locate
specified tracks.
specified tracks.
The disc is very dirty?
Clean the disc.
The disc is scratched?
Replace with a new disc.
USB setup has been
completed, but the “new
device detected” window
keeps appearing.
completed, but the “new
device detected” window
keeps appearing.
Windows has become
unstable.
unstable.
Restart your PC.
Symptom
Possible cause
Remedy