Hitachi 42pd9r10 Manual Do Utilizador
12
PREPARATION
This remote control operates on 2 “AA” batteries.
1. Open the battery compartment
cover
cover
Slide open the battery
compartment cover on the
backside of the remote control in
the direction of an arrow.
backside of the remote control in
the direction of an arrow.
CAUTION
It could cause corrosion or battery leakage and may result in physical injury
and/or property damage including fi re.
and/or property damage including fi re.
Never mix used and new batteries in the device.
Replace all the batteries in a device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
Replace all the batteries in a device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible failure, read the following instructions and handle the
remote control properly.
remote control properly.
Do not drop or cause impact to the remote control.
Do not spill water or any liquid on the remote control.
Do not place the remote control on the wet object.
Do not place the remote control under the direct sunlight or near sources of excessive heat.
Do not spill water or any liquid on the remote control.
Do not place the remote control on the wet object.
Do not place the remote control under the direct sunlight or near sources of excessive heat.
Caution When Moving the Main Unit
As this product is heavy, whenever it is moved, two people are required to transport it safely.
42PD9700U/C
Whenever the unit is moved,
it should be lifted forwards
using the two handgrips at
the back, and the unit should
then be held at the base on
both sides for stability.
Whenever the unit is moved,
it should be lifted forwards
using the two handgrips at
the back, and the unit should
then be held at the base on
both sides for stability.
55PD9700U/C
When carrying this product,
hold it by the top and bottom
on both ends.
When carrying this product,
hold it by the top and bottom
on both ends.
Handgrips
2. Install the batteries
Install 2 “AA” batteries (included) making
sure the polarities match the indication
inside the compartment.
inside the compartment.
3. Close the battery compartment cover.
To close the battery compartment
cover, slide the cover in the
direction of an arrow till it clicks
shut.
direction of an arrow till it clicks
shut.
Use the remote control within about 5m from
front of the unit’s remote-control sensor and
within 30 degrees on both sides.
front of the unit’s remote-control sensor and
within 30 degrees on both sides.
Within 30
degrees
degrees
About 5m
About 3m
Within 30
degrees
degrees
About 3m
Remote Control Batteries Installation
Handling the Remote Control