ONKYO CDR-205X Manual Do Utilizador

42

If the CDR-205X begins to operate improperly, use the troubleshooting guide below to help you ascertain the
problem.
Because the unit contains a microcomputer to provide advanced functions, it may malfunction due to
external noise or static electricity. If this happens, disconnect the power cord and then plug it in again after
about 5 seconds.

The CDR-205X is equipped with a self-diagnosis function. If a malfunction is detected during operation, one
of the messages given below will appear in the front display.

Disc Error

• Playback was likely stopped due to dirt,

• Eject the disc and check for dirt, dust,

dust, scratches, or vibrations.

and scratches (see page 16).

• The disc has been placed in

• Eject the disc and check that it is placed

upside down.

in correctly (see page 16).

If you place the disc correctly and the
same message appears, unplug the power
cord and plug it back in again. If the same
message appears again, contact an Onkyo
service representative.

Sys. Error

A malfunction has occurred in the system

Unplug the power cord and plug it back

(flashing)

due to excessive noise or static electricity.

in again. If the same message appears
again, contact an Onkyo service
representative.

Cannot Copy

The input digital signal contains

Record an analog signal or recordable

a copy guard signal (SCMS).

music signal (see page 48).

Cannot Rec

• The digital input is blocked.

• Verify that the player component is

properly playing and the digital cable is
properly connected. (see page 12).

• Data has been input in the

• Verify that source signal is a normal

CD-ROM, etc.

music signal (see page 18).

Check Input

The player component was already

Stop the player component. Shortly thereafter,

↓ ↑

playing.

"Signal Wait" will appear (see page 28).

Rec Setup

Rec Setup

The CDR-205X is entering the

Wait until the message disappears.

recording standby state.