Hitachi 42pma400e Manual Do Utilizador
9
ENGLISH
Remote controller
AUTO
PinP
SIZE
MUTE
VOL
VOL
RECALL
RGB 1
RGB 2
ENTER
VIDEO 1
VIDEO 2
MENU
RETURN
ID
ID SET
ID SET button
17
POWER OFF button
14
POWER ON button
14
POWER ON/OFF button
14
MENU button
17
MUTE button
15
RGB/VIDEO buttons
15
VOLUME UP/DOWN button
15
RETURN button
17
RECALL button
16
AUTO button
17
PinP button
16
SIZE button
16
ID button
17
SELECT/ADJUST buttons
17
ENTER button
17
Loading Batteries
1. Open the battery cover.
• Slide back and remove the battery
cover in the direction of the arrow.
2. Load batteries.
• Load two Size AA batteries included observing the correct
polarities.
3) Close the battery cover.
• Replace the battery cover in the direction of the arrow and snap
it back into place.
Use the remote controller within about 5 m from front of the unit’s
remote-control sensor and within 30 degrees on both sides.
remote-control sensor and within 30 degrees on both sides.
AUTO
PinP
SIZE
MUTE
VOL
VOL
RECALL
RGB 1
RGB 2
ENTER
VIDEO 1
VIDEO 2
MENU
RETURN
ID
ID SET
With in 30
degrees
degrees
About 5m
About 3m
With in 30
degrees
degrees
About 3m
• Do not use new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
• When loading batteries, observe their correct polarities as
marked on the product. If loaded in the wrong direction, the
batteries could explode or leak, resulting in fires, physical injury,
or stains.
batteries could explode or leak, resulting in fires, physical injury,
or stains.
CAUTIONS
TIPS
• Do not drop or impact the remote controller.
• Do not splash the remote controller with water or put it on a wet
• Do not splash the remote controller with water or put it on a wet
object to avoid possible failures.
• Before leaving the remote controller out of use for an extended
period of time, remove the batteries from it.
• If the remote controller begins to lack responsiveness, replace
the batteries.
• Strong light such as direct sunlight impinging on the
photoreceptor of the remote control can cause operational
failure. Position this unit to avoid direct contact with such light.
failure. Position this unit to avoid direct contact with such light.
Handling the Remote Controller
Component Names (continued)