Hitachi gf-2000 Manual Do Utilizador
Setup: Hitachi GF-2000 4.7G DVD-RAM User's Guide
Set up will vary based upon the reseller providing the DVD-RAM drive. Please refer to the documentation recieved with your system
for additional information.
If the included drivers are properly installed, when the user is in My Computer, the screen will then display the following icon:
DVD-RAM icon
If the OS is reinstalled without installing the included drivers:
The drive will be seen as a CD-ROM under Windows NT 4.x, Windows 2000 and Windows 98 SE and will read DVD-ROM data discs
and DVD-RAM discs that have been finalized as ISO9660 discs without any special drivers. Under Windows 2000 and Windows 98 SE,
it can also read DVD-RAM discs that have been formatted with UDF version 1.02 or version 1.5 without any special drivers. [Those
versions of UDF are only supposed to be used on 2.6 G/5.2 G media not on 4.7G/9.4G media; however, it is possible to format 4.7G/
9.4G media with UDF 1.5, in which case, it can be read.]
Drives Purchased Separately as Customer Kits
Procedure:
1. Install the DVD-RAM reader.
Remove the DVD-RAM reader from its packaging
Turn off the power to your computer and unplug the power cord
Remove the cover, face plate and clips or brackets used to secure internal devices
Please check the manual of your computer or contact to customer service when you mount the DVD-RAM reader to
your computer
If you are upgrading from another DVD-RAM reader, determine whether your old reader has an IDE interface, then
disconnect and remove the old reader from your bay
2. Locate the secondary IDE connector.
3. Connect to your existing secondary IDE connector.
4. Connect the audio cable between the DVD-RAM drive and the sound card.
5. Connect the power cable.
6. Close your computer.
7. Install your driver software.