Honeywell T7147 Manual Do Utilizador

3

63-4065—1

Read these instructions carefully. Failure to follow 
them could damage the product or cause a hazardous 
condition.

Check the ratings given in the instructions and on the 
product to make sure the product is suitable for your 
application.

Installer must be a trained, experienced service 
technician.

After installation is complete, check out product 
operation as provided in these instructions.

Electrical Shock or Equipment Damage Hazard.
Can shock individuals or short equipment 
circuitry.
Disconnect power supply before installation.

Select a location on an inside wall away from:
•

drafts or dead air spots behind doors and corners.

•

hot or cold air ducts.

•

radiant heat from the sun or electrical equipment.

•

unheated areas behind the thermostat wall.

Locate the T7147 about 5 ft (1.5 m) above the floor in an 
area with good air circulation within easy reach of users.

Loosen the cover-locking screw with the Allen wrench 
provided and remove the T7147 cover.

Run wire to the selected location.

Thread wire through T7147 base semicircular hole.

Make connections to T7147 (see Wiring section).

If air drafts occur through the wall opening, eliminate 
them with suitable insulation material.

Four mounting screws are provided:
a. 2 self-tapping type for wall mounting.
b. 2 for outlet box mounting.

Select the proper screws for the application.

Fasten the T7147 to the wall or outlet box with screws 
through the T7147 base assembly mounting holes.
(See Fig. 3).

Replace the cover assembly and tighten the cover-
locking screw.

THERMOSTAT

MOUNTING
TAB SLOT (2)

WIRING 
TERMINALS

MOUNTING 
TAB 
(2 INSIDE 
COVER)

MOUNTING 
SCREW (2)

COVER 
LOCKING 
SCREW

OUTLET BOX

M17884

WALLPLATE

COOLER

3 HOUR

OCCUPIED

WARMER