Crestron cnxenet plus Manual Do Utilizador

Página de 32
Crestron CNXENET+ 
CNX Enhanced Ethernet Expansion Card
 
Installation 
Installation into CNMSX-AV/PRO 
Items 1 through 9 listed below for the installation of the CNXENET+ are either 
attached to the card or already reside on the control system. The tools required are a 
grounding strap, a #1 Phillips tip screwdriver, and a #2 Phillips tip screwdriver. 
Follow the assembly procedure after this paragraph.  
Referenced Items for CNMSX Installation 
ITEM
DESCRIPTIO N
PART NUM BER
Q UANTITY
1
Screw, 6-32 x 1/4"L, steel, 
flat, phillips, undercut, black
SR06-32-0R2500-8
4
2
Screw, 6-32 x 3/8"L, steel, 
flat, phillips, undercut, black
SR06-32-0R3750-9
12
3
Control System  Top Cover
M TCV02376-1
1
4
Screw, 6-32 x 1/4"L, zinc, 
pan, phillips, black
SR06-32-0R2500-2
6
5
I/O Printed Circuit Board
PA05632-1
1
6
Screw, 4-40 x 3/8"L, steel, 
pan, phillips, black
SR04-40-0R3750-3
2
7
W asher, lock, steel, internal 
tooth, #4, zinc
W A04LO -1
2
8
Plate, blank, m etal, LAN/DPA M TPL02390-1
1
9
CNXENET+
ZA11281
1
 
CAUTION:  The CNXENET+ and the control system contain electro-static 
discharge (ESD) sensitive devices. Perform the following procedure while wearing a 
grounding strap that is properly grounded or on a grounded work station to avoid 
damaging the card and/or the control system.  
CAUTION:  Refer to the latest revision of the CNMSX Operations Guide (Doc. 
8118) for proper turn-off and, if applicable, removal procedures. The latest software 
version can be obtained from the Products page (PRODUCT MANUALS, Hardware 
section) or Downloads page (MANUAL Library) of Crestron’s website 
(www.crestron.com). New users are required to register in order to obtain access to 
the FTP site. 
NOTE:  The unit shown in this procedure is a CNMSX-AV. The procedure is 
identical for the CNMSX-PRO.  
NOTE:  It is assumed that the control system rack ear brackets are not attached 
during this installation procedure.  
1.  As shown on the next page, place the control system right-side-up on a 
flat surface and using a #2 Phillips tip screwdriver, remove four screws 
 from the top of the unit.  
Operations & Installation Guide – DOC. 8153A 
CNX Enhanced Ethernet Expansion Card: CNXENET+  
  3