Crestron cnxenet plus Manual Do Utilizador

CNX Enhanced Ethernet Expansion Card 

Crestron CNXENET+

3

1

2

REAR PANEL

(REFERENCE ONLY)

 

2. Remove 

six screws   from each side of the control system. 

3.  Lift and remove control system top cover  .  

4.  As shown below, remove six screws   that secure I/O printed circuit 

board   to the control system. 

8

7

4

5

6

REAR PANEL

(REFERENCE ONLY)

 

5.  Slide the I/O printed circuit board   toward the front panel of the 

control system so that the rear connectors are clear of the rear panel 
slots and reposition the I/O printed circuit board   to gain access to the 
LAN/DPA cover plate  . 

6.  Using a #1 Phillips tip screwdriver, remove two screws   and two 

lock washers   that secure the LAN/DPA cover plate   to the control 
system rear panel. 

7.  From inside the control system, remove the LAN/DPA cover plate  .  

8.  For older model control systems, carefully push the computer interface 

ribbon cable aside to make room for the CNXENET+. For newer 
systems, make sure that cable does not interfere with CNXENET+ 
placement. 

•  CNX Enhanced Ethernet Expansion Card: CNXENET+