Honeywell MS-9600LSE Manual Do Utilizador

MS-9600LS Series Manual — P/N 52646:B2  2/12/2010

103

Programming

The control panel time and date can be changed by pressing 3 while viewing the System Setup 
Screen #1.  The following screen will be displayed:



To change the time, press 1 while viewing the Time-Date Screen.  The following screen will be dis-
played: 

A flashing cursor is located toward the top left of the display.  Below the cursor is the current time.  
To change the time, enter the two-digit hours followed by the two-digit minutes.  The cursor will 
move one position to the right each time a digit is entered.  After the last minutes digit is entered, 
the cursor will again move one position to the right.  At this point enter 1 for AM or 2 for PM.  The 
display will then return to the Time-Date Screen which will show the new time entry.  If an error is 
made while entering a digit, press the CLR key to delete the entire entry and beginning again.



To change the date, press 2 while viewing the Time-Date Screen.  The following screen will be dis-
played: 

A flashing cursor is located toward the top left of the display.  Below the cursor is the current date.  
To change the date, enter the two-digit month followed by the two-digit day and then the two-digit 
year (09 for 2009, 10 for 2010, etc.).  The cursor will move one position to the right each time a 

   SYSTEM SETUP

1=TROUBLE REM

2=BANNER

3=TIME-DATE

System Setup Screen #1

   TIME AND DATE

1=TIME  10:00 AM

2=DATE  02-04-2010

3=CLOCK FORMAT  12HR

   TIME AND DATE

1=DAYLIGHT SAVINGS

     ENTER TIME

10:00 AM

1=AM            2=PM

     ENTER DATE

MONTH DAY YEAR

02-04-2010