Vermont Castings lher20 Manual Do Utilizador
LHEACNSS Contour
Trim Kit
Trim Kit
Installation Instructions
Kit: KT1B80
for Models LHEC30,
LHEC20, LHER20
for Models LHEC30,
LHEC20, LHER20
These instructions cover the assembly of the KT1B80
Trim Kit and installation to the LHEC30, LHEC20 and
LHER20 fireplace inserts.
Carefully unpack and inspect all components from the
shipping box. Report any missing or damaged parts to
your dealer immediately. Install trim kit after all other
fireplace installation work has been completed, thor-
oughly checked and tested for proper operation, leaks
and installation requirements.
Trim Kit and installation to the LHEC30, LHEC20 and
LHER20 fireplace inserts.
Carefully unpack and inspect all components from the
shipping box. Report any missing or damaged parts to
your dealer immediately. Install trim kit after all other
fireplace installation work has been completed, thor-
oughly checked and tested for proper operation, leaks
and installation requirements.
Caution
Always place castings on a flat protected work sur-
face, such as a towel, blanket or carpet.
face, such as a towel, blanket or carpet.
Tools required: Tape measure
Trim kit parts
Trim kit parts
Part #
Column Right Assembly
30002073
(1) Column, right
30001978
(1) Boot, right
30001982
(1) Slider Clip, right
30002050
(1) Bracket, On/Off Switch
10005035
(2) 1/4-20 Round Head Screw
1200894
(2) 1/4-20 Wing Screw
1201621
(3) 1/4 Flat Washer
1202474
Column Left Assembly
30002074
(1) Column, left
30001979
(1) Boot, left
30001983
(1) Slider Clip, left
30002049
(1) 1/4-20 Round Head Screw
1200894
(2) 1/4-20 Wing Screw
1201621
(3) 1/4 Flat Washer
1202474
Key
30001981
Upper Mounting Bracket
30002053
Upper Mounting Bracket R
30002054
Hardware Bag:
30001988
(5) 1/4-20 Wing Screw
1201621
(5) 1/4 Flat Washer
1202474
Instruction Sheet
30001987
Assembly
Determine which model fireplace insert you have. This
will be important when adjusting the height and width of
the surround.
1. Place the key (30001981) on your work surface with
will be important when adjusting the height and width of
the surround.
1. Place the key (30001981) on your work surface with
the threaded holes facing up.
2. Place the column right assembly (30002073) onto
the key. (Fig. 1)
3. Place the column left assembly (30002074) onto the
key. (Fig. 2)
KT424
column right
assy
9/03
Key
Column Right Assembly
KT424
Fig. 1 Place column right assembly onto key.
KT425
column left
assy
9/03
Key
Column Left
Assembly
KT425
Fig. 2 Place column left assembly onto key.
30001987 8/08 Rev. 4
4. Install the upper mounting bracket. Use the upper
mounting bracket marked R (30002054) for the
LHER20. Use the unmarked upper mounting bracket
(30002053) for LHEC30 and LHEC20. (Fig. 3)
LHER20. Use the unmarked upper mounting bracket
(30002053) for LHEC30 and LHEC20. (Fig. 3)