Vermont Castings lher20 Manual Do Utilizador

5. Fasten the upper mounting bracket to the key with

a 1/4-20 wing screw and 1/4 ﬂat washer ﬁnger tight.
(Fig. 3)

6. Fasten the upper mounting bracket to both column

assemblies using (2) 1/4-20 wing screws and (2)
1/4 ﬂat washers per side ﬁnger tight. The distance
between the insides of the columns should measure:

   LHEC30 = 29³⁄₁₆” (741mm)
   LHEC20 & LHER20 = 25⁵⁄₈” (651mm)
7.  Adjust the column/boot length (measure from the

bottom side of the key to the bottom of the boot).

   LHEC30 = 22¹⁄₄” (565mm)
   LHEC20 = 18¹⁄₄” (464mm)
   LHER20 = 17⁵⁄₈” (448mm)
8.  Lift the surround up and parallel to the ﬁreplace

front. Press the Fan ON/OFF switch into the switch
bracket. It will snap into place. (Refer to Homeown-
er’s manual for additional switch installation instruc-
tions) Move the surround towards the ﬁreplace about
an inch above the hearth. As you lower the surround
onto the ﬁreplace, the side clips and top bracket will
engage mating clips. If height and width adjustments
are required, lift the surround up and out. Make the
adjustments. Regardless if adjustments were made
or not, tighten all wing screws fasteners and return
the surround to the ﬁreplace.

KT436

upper mounting

bracket

9/03

1/4-20 Wing

Screw

1/4 Flat

Washer

Upper Mounting

Bracket

KT426

Fig. 3 Install upper mounting bracket.

Boot

Slider Clip

MHSC

149 Cleveland Drive • Paris, Kentucky 40361