U-Line CLRCO2075 Manual Do Utilizador

www.U-LineService.com

02/2005

™

1. Open the water supply valve in the main water source.

2. Make sure the cycle selector switch is in the OFF 

(middle) position (see Figure 46).

Note: If the cycle selector switch is in the ON or CLN 
position, water will immediately start flowing into the 
unit when it is first plugged into the electrical outlet.

3. Plug in the power cord.

4. Gently push the unit into position. Be careful not to 

kink the drain or water supply line or entangle the 
electrical cord. 

5. Re-check the leveling, from front to back and side to 

side. Make any necessary adjustments. The unit’s top 
surface should be approximately 1/8" below the 
countertop.

6. Test the drain system by pouring one gallon of water 

into the ice bin. The water should drain freely and there 
should be no leakage.

7. Remove the tape from the glass shelves and wipe out 

the inside of the unit with a clean, water-dampened 
cloth.

Both the glass shelves in the refrigerator and the inner 
door shelves can be moved to accommodate your bottles, 
cans and containers.

1. Open door fully, grasp shelf firmly, lift front edge 

slightly, and pull straight out.

2. Choose new location and slide shelf onto the 

appropriate rib.

1. See Figure 44. Pull shelf 

out about 6” to clear the 
wall’s molded protrusion.

2. Tilt right-hand edge of 

shelf up.

3. Keeping at this angle and 

hugging the right wall, 
pull the shelf out.

4. Choose new location and 

insert over ribs, tilting 
right-hand edge up. Push 
in, then lower shelf onto 
ribs.

1. First pull shelf up at a 45° 

angle, then straight out 
(see Figure 45).

2. Choose new location and 

line up on bosses. First 
push straight in, then 
down at a 45° angle.

Water is leaking under the unit.

A water leak under the unit is most likely caused by a bad 
connection in the water supply line. Make sure the water 
line’s brass fitting is screwed tight to its valve and 
threaded correctly. Make sure the fill tube’s connection to 
the water line is also tight. Check drain line to make sure 
it has not been disconnected from drain connection on 
back of the unit or disconnected from the drain.

The door remains open unless it is pushed closed.

The hinges should be self-closing when the door is open 
approximately 8". If this is not the case, make sure the 
closers (at the bottom of the hinge pin) are clean, greased 
and installed correctly. Also, re-check leveling from front 
to back of the unit and readjust if necessary. Make sure 
that pivot plate is installed correctly.

The custom overlay door was designed to align with the 
rest of the cabinet doors, but the unit has crept forward.

First, make sure that the electrical cord and water supply 
line are not obstructing the installation. If they are not, 
there is mostly likely not enough room allowed for the 
drain connection on the rear of the unit. You may need to 
alter the wall behind the unit to accommodate the drain 
connection.

1. Pull Out 6"

2. Tilt

3. Pull

Boss

Notch