Kenwood TS-590S Manual Do Utilizador

36

If you operate both SSB and CW modes, you can 
configure the transceiver to change the operating 
mode from SSB (USB or LSB) to CW and then 
transmit in CW mode automatically when you operate 
the CW keyers.

The mode automatically changes from USB to CW 
and LSB to CWR, regardless of the setting for Menu 
No. 42 (Frequency correction for changing SSB to 
CW). Therefore, when the CW signal is received in 
SSB mode, you can operate the paddle or keyer to 
immediately communicate CW with another station.

1 Press [MENU], then press [Q-M.IN]/ [Q-MR] or 

turn the MULTI/CH control to access Menu No. 41.

2 Press [M.IN] to select “on”.

3 Press [MENU] to exit Menu mode.

Note:  You must switch the CW Break-in function ON to change 
the mode and transmit in CW mode {page 32}.

This function allows you to send CW messages 
without using an optional paddle {page 2}.  The Mic 
[UP] key can be used as the dot paddle and the Mic 
[DWN] key can be used as the dash paddle.

To activate Mic UP/ DWN key Paddle mode:

1 Press [MENU], then press [Q-M.IN]/ [Q-MR] or 

turn the MULTI/CH control to access Menu No. 40.

2 Press [M.IN] to select “PA”.

3 Press [MENU] to exit Menu mode.

•

Press and hold Mic [DWN] to send dots or Mic 
[UP] to send dashes in CW mode.

4 To exit Mic UP/ DWN key Paddle mode, access 

Menu No. 40 and select “PF”.

This function reverses the position of the dot and dash 
paddle positions.  As a default, the left paddle sends 
dots and the right paddle sends dashes.  When this 
function is ON, the left paddle will send dashes and 
the right paddle will send dots.

1 Press [MENU], then press [Q-M.IN]/ [Q-MR] or 

turn the MULTI/CH control to access Menu No. 39.

2 Press [M.IN] to select “on”.

3 Press [MENU] to exit Menu mode.

•

The left paddle now sends dashes and the right 
paddle now sends dots.  To return to the normal 
paddle positions, access Menu No. 39 and 
select “oFF”.