Nautilus t516 Manual Do Utilizador

9-8  Plug the wires into the new dual board using the 

wiring diagram provided in Appendix 1 and 2 . 

9-9  Plug the power cord into the wall outlet and start 

the treadmill. If the waking belt has a surging 
motion you can correct this by slightly turning the 
“IR Comp” adjustment pot on the dual board (see 
Figure 4 and 4A). 

9-10  If the belt speed is too low during calibration 

adjust the max “speed” pot to achieve proper 
setting. After changing these settings you should 
recalibrate (see Figure 4 & 4A). 

9-11  Replace the motor cover first, then replace the 

lower outer plastic covers using (4) Phillips head 
screws per side, and the lower inside upright 
plastic cover using (4) Phillips head screws per 
side.