Kenwood TK-5410 Manual Do Utilizador

22

■

 

If a key has been programmed with 

Individual, you can 

make calls to specified persons.
1  Press the key programmed as Individual.
2  Press the Side 2 and Side 3 keys to select a unit ID from 

the list that has been pre-entered into your transceiver.

•  On K3/K model transceivers, you can enter a unit ID by 

pressing the DTMF keypad instead.

•  The target unit ID/name appears on the display.

3  Press and hold the PTT switch to make the call.

•  Speak into the transceiver as you would during a normal 

transmission.

•  On Trunking channels, a ringing tone will sound and the 

display will alternate between the called unit ID/name and 

“CALLING”.

4  On Trunking channels, to end the call, press the Side 1 

key or the keypad 

# key.

1  Select the desired zone and channel using the selector 

knob and the 

Zone Up/  Zone Down or Channel Up/ 

Channel Down keys.  (If the Scan function has been 

programmed, you can switch it on or off as desired.)

2  When you hear a caller’s voice, readjust the volume as 

necessary.

•  If the vibrator function is on, the transceiver will vibrate when a 

call is received.

•  If signaling has been programmed on the selected channel, 

you will hear a call only if the signal tone matches the tone set 

up on your transceiver.

Note:  Signaling allows your transceiver to code your calls.  

This will prevent you from listening to unwanted calls.  It does 

not make calls private, it only prevents them from being heard 

by transceivers set with a different signaling code.  Refer to 

“SIGNALING” on page 3 for details.