Brother MFC-6800 Manual Do Utilizador

      A S S E M B L Y   A N D   C O N N E C T I O N S

The external TAD must be plugged into the left  side of the MFC, into the jack 
labeled EXT. Your MFC cannot work properly if you plug the TAD into a wall 
jack (unless you are using Distinctive Ring).

Plug the telephone line cord from the wall jack into the left side of the MFC, in 
the jack labeled LINE.

Plug the telephone line cord from your external TAD into the left side of the 
MFC, in the jack labeled EXT. (Make sure this cord is connected to the TAD at 
the TAD’s telephone line jack, and not its telephone set jack.)

Set your external TAD to four rings or less. Two rings are recommended. 
(The MFC’s Ring Delay setting does not apply.)

Record the outgoing message on your external TAD (see next page).

Set the TAD to answer calls.

Set the Receive Mode to 

Timing is important in recording this message.

Record 5 seconds of silence at the beginning of your message. (This allows your 
MFC time to listen for the fax CNG tones of automatic transmissions before 
they stop.)

Limit your speaking to 20 seconds.

End your 20-second message by giving your Fax Receive Code for people 
sending manual faxes. For example:
“After the beep, leave a message or send a fax by pressing   51 and Start.”

Do not connect a TAD elsewhere on the same phone line (unless you have 
the Distinctive Ring service).