Nortel Networks meridian m3905 Manual Do Utilizador

S-registers

S1 (ring count; read only)

This returns the current number of rings for an incoming data call when read.

S2 (escape character; range = 0–255)

This holds the ASCII value of the escape character. If the S2 register is set to a
value of 128 or greater, then escape character action is disabled.

S3 (carriage return character; range = 0–127)

This holds the ASCII value of the carriage return (used for command line
termination and prompt termination). The default is 13.

S4 (line feed character; range = 0–127)

This holds the ASCII value of the line feed character. The default value is 10.

S5 (backspace character; range = 0–32, 127)

This holds the ASCII value of two values, one for the backspace key and one for
the character echoed to move the cursor back one position.

S9 (carrier detect response time)

Not applicable.

S10 (lost carrier hand up delay)

Not applicable.

S11 (DTMF tone duration)

Not applicable.

S6 (waiting time before blind typing)

Not applicable.

S7 (wait time for carrier/dial tone; range = 1–255)

This holds the Carrier Detect time-out value. When the time (in seconds) elapses,
the attempted call is released. The default value is 30 seconds.