Netgear WG302 Manual Do Utilizador

6-2

Troubleshooting

•

Make sure the power adapter is connected to a functioning power outlet. If it is in a power 
strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify that it 
is not a switched outlet.

•

Make sure you are using the correct NETGEAR power adapter supplied with your access 
point.

The access point’s antennae are not working.

•

If the Wireless LAN activity light stays off, disconnect the adapter from its power source and 
then plug it in again. 

•

Make sure the antennas are tightly connected to the WG302. 

•

Contact NETGEAR technical support if the Wireless LAN activity light remains off.

There is a hardware connection problem.Check these items:

•

Make sure the cable connectors are securely plugged in at the access point and the network 
device (hub, switch, or router). A switch, hub, or router must be installed between the access 
point and the Ethernet LAN or broadband modem.

•

Make sure the connected device is turned on.

•

Be sure the correct cable is used. Use a standard Category 5 Ethernet patch cable. If the 
network device has Auto Uplink™ (MDI/MDIX) ports, you can use either a crossover cable or 
a normal patch cable.

There is a configuration problem. Check these items:

•

You may not have restarted the computer with the wireless adapter to have TCP/IP changes 
take effect. Restart the computer.