Cisco Systems 350 Manual Do Utilizador
3-7
Cisco Aironet Access Point Hardware Installation Guide
OL-0738-02
Chapter 3 Basic Configuration
Entering Basic Settings
Using a Terminal Emulator
This section provides instructions for Microsoft’s HyperTerminal; other programs are similar.
Selecting Pages and Settings
When you type names and settings that appear in brackets you jump to that page or setting.
HyperTerminal jumps to the page or setting as soon as it recognizes a unique name, so you need to type
only the first few characters in the page or setting name. To jump from the home page to the Setup page,
for example, you would only need to type se.
HyperTerminal jumps to the page or setting as soon as it recognizes a unique name, so you need to type
only the first few characters in the page or setting name. To jump from the home page to the Setup page,
for example, you would only need to type se.
Applying Changes to the Configuration
The console interface’s auto-apply feature is on by default, so changes you make to any page are applied
automatically when you move to another management page. To apply changes and stay on the current
page, type apply and press Enter.
automatically when you move to another management page. To apply changes and stay on the current
page, type apply and press Enter.
Assigning Basic Settings
Follow these steps to assign basic settings to the access point with a terminal emulator:
Step 1
Connect a nine-pin, male-to-female, straight-through serial cable to the COM port on a computer and to
the RS-232 serial port on the back of the access point.
the RS-232 serial port on the back of the access point.
show the location of
the access point’s serial port.
Figure 3-1
Connecting the Serial Cable for 340 Series and 350 Series Access Points
ETHERNET
SERIAL
SERIAL
5VDC
9-pin serial extension
cable to PC COM port
cable to PC COM port
RS-232