dreamvision dl-500 Manual Do Utilizador
12
A TV-tuner is (Mac Optional) for the
DreamVision DL500
DreamVision DL500
NOTE! Requires TV tuner to be installed.
In order to use the DreamVision DL500 as a TV output;
connect the TV antenna to the TV connector on the
DreamVision DL500 plug panel.
connect the TV antenna to the TV connector on the
DreamVision DL500 plug panel.
The DreamVision DL500 behaves just like a normal TV.
See the menus section 7.2.6 on how to adjust the TV
settings.
See the menus section 7.2.6 on how to adjust the TV
settings.
There are basically three ways of receiving the TV
signals to the DreamVision DL500:
signals to the DreamVision DL500:
◆
Antenna (Terrestrial)
◆
Cable
◆
Set-up box for satellite
These three work differently and it is important to
consider the options of each when adjusting the
DreamVision DL500 settings.
consider the options of each when adjusting the
DreamVision DL500 settings.
Antenna
When you adjust your TV to signals from an antenna
you must store each channel in a different program. .
The same is true for the DreamVision DL500 TV-tuner.
When connected to an antenna you assign the different
channels to the programs in the Television Setup Menu.
Then you use the Up and Down arrows
in the menu, remote control or the channel up/down
button on the control panel to switch between channels.
When you adjust your TV to signals from an antenna
you must store each channel in a different program. .
The same is true for the DreamVision DL500 TV-tuner.
When connected to an antenna you assign the different
channels to the programs in the Television Setup Menu.
Then you use the Up and Down arrows
in the menu, remote control or the channel up/down
button on the control panel to switch between channels.
5. Connecting a TV- source to the
DreamVision DL500
Figure 11: Connecting to TV- source
1183 (ELEK). LiteBeam ENG 15.10.98 14:16 Side 12