opcode studio 4 Manual Do Utilizador

NOTE: If you have never used OMS, you 
should stop and read the OMS manual 
before continuing with the Studio 4 
manual.

The Studio 4 uses the OMS Setup and 
Studio Patches Editor applications with 
the Studio 4 OMS driver to control all 
mapping, channelizing routing and time-
code functions.

Follow the installation instructions on the 
OMS disk to install OMS and the Studio 4 
software.

The Installer places all the necessary 
OMS and Studio 4 files onto your hard 
disk automatically. After running the 
Installer and restarting your Macintosh, 
you can begin to use OMS and your 
Studio 4.

NOTE: You must install the Studio 4 OMS 
driver to use the Studio 4. The Studio 4 
requires OMS version 1.2 or later.

See the OMS manual to learn about the 
various OMS files and where they’re 
installed.

The Studio 4 package includes some addi-
tional files that aren’t part of basic OMS:

•

Studio Patches Editor —This appli-
cation adds the ability to create OMS 
patches. OMS patches are discussed 
in Part Three of this manual.

•

OMS Program Changes—This 
driver allows you to change OMS 
patches from Macintosh applications 
and is installed in the OMS Folder 
within the System Folder. See 
“Sequencing Patch Changes” in 
Chapter 11 for more information.

•

Studio 4 OMS Driver—This driver 
allows OMS to operate with your 
Studio 4 and is installed in the OMS 
Folder within the System Folder.

CAUTION: Do not relocate or rename any 
files or folders that the Installer places in 
the System Folder. You may delete unneces-
sary files, but some files are essential for 
OMS operation. See the Software Defini-
tions section of your OMS manual for more 
information.

Although the Studio 4 works with non-
OMS applications, all programming and 
setup of the Studio 4 is handled by OMS.