sentrol zxled12 Manual Do Utilizador

42

you have silenced a Fire Alarm, you will need to reset the smoke
detector.  Press the RESET SMOKE key (7) and enter your passcode.
The trouble condition should disappear on the zone in a couple of
seconds.  If the trouble condition does not clear after resetting the
smoke detector, contact your installer for service.

Preparation and education are of prime importance in the prevention of
fire.  An evacuation plan should be established BEFORE a severe
situation arises.  Your security system may or may not contain fire
detection and notification equipment.  Make sure your Security Com-
pany Representative fully explains the configuration of your system.
Make sure you fully understand the limitations of your system.

Use the following steps in establishing an evacuation plan:

1.

Evaluate all possible escape routes from your home and draw a
floor plan.

2.

Select two exit escape routes from each room.

3.

Provide escape ladders for rooms above the first floor.  Check the
ladders to be sure that they will reach the ground.

4.

Draw a rough sketch of your escape plan so that everyone is
familiar with it.

5.

Practice your escape plan to assure that everybody knows what
they have to do in a severe situation.

6.

Establish a meeting place outside where your family is to report.

7.

Advise the local fire authority if you have installed a fire alarm
system.

Discuss the following with all residents:

1.

Familiarity with alarm signals.

2.

Status of bedroom doors.

3.

Testing of door during a fire and use of alternate escape routes if
HOT to touch.

4.

Crawling and holding breath techniques during a fire.

5.

ESCAPE  FAST, DO NOT STOP for packing.

6.

Emphasize that no one is to return to a burning building.