Puls UC10.241 DIN-Rail UPS Guia De Especificação
UC10.241, UC10.242
UC-Series
24V,
15A,
C
APACITOR
-
BASED
B
UFFER
M
ODULES
I
NDEX
Page
Page
The information presented in this document is believed to be accurate and reliable and may change without notice.
No part of this document may be reproduced or utilized in any form without permission in writing from the publisher.
T
ERMINOLOGY AND
A
BREVIATIONS
Buffer Module
Short term buffer system with DC-In-/Output. Utilizes capacitors as energy source
DC-UPS
Uninterruptible power supply system with DC-In-/Output. Utilizes batteries as energy source
Normal mode
Describes a condition where the capacitor is charged, the input voltage is in range and the
output is loaded within the allowed limits.
output is loaded within the allowed limits.
Buffer mode
Describes a condition where the input voltage is below the transfer threshold level, the unit is
running on capacitor (buffering) and the output is loaded within the allowed limits.
running on capacitor (buffering) and the output is loaded within the allowed limits.
Charging mode
Describes a condition where the capacitor is being charged, the input voltage is in range and
the output is loaded within the allowed limits.
the output is loaded within the allowed limits.
Inhibit mode
Describes a condition where buffering is disabled on purpose (e.g. for service actions)
T.b.d.
To be defined, value or description will follow later.
AC 24V
A figure displayed with the AC or DC before the value represents a nominal voltage with
standard tolerances included.
E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)
standard tolerances included.
E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)
24Vac
A figure with the unit (Vac) at the end is a momentary figure without any additional
tolerances included.
tolerances included.
may
A key word indicating flexibility of choice with no implied preference.
shall
A key word indicating a mandatory requirement.
should
A key word indicating flexibility of choice with a strongly preferred implementation.
Apr. 2014 / Rev. 2.0 DS-UC10.241-EN (REVC)
All parameters are specified at 24V, 10A output current, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
All parameters are specified at 24V, 10A output current, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone +49 89 9278 0 Germany
2/27