Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16 Guia De Especificação

Use the configure terminal command at the EXEC prompt. You are prompted as follows:

Router# configure terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)#

Using the config-register 0x value command, change the configuration register value back to its original
value (noted in

) or change it to a value of 0x0102 (factory default).

Exit global configuration mode using Ctrl-Z or by typing end.

Reboot the router and enable it using the recovered password.

This completes the procedure for recovering a lost password.

The following sections include important reference information:

The console port on the RSP16 is an EIA/TIA-232, DCE, DB-25 receptacle. Both Data Set Ready (DSR)
and Data Carrier Detect (DCD) are active when the system is running. The Request To Send (RTS) signal
tracks the state of the Clear To Send (CTS) input. The console port does not support modem control or
hardware flow control. The console port requires a straight-through EIA/TIA-232 cable.

lists the

signals used on this port.

1

GND

–

Ground

2

TxD

<—

Transmit Data

3

RxD

—>

Receive Data

6

DSR

—>

Data Set Ready (always on)

7

GND

–

Ground

8

DCD

—>

Data Carrier Detect (always on)