Exegin Technologies Limited Q53 Manual Do Utilizador

16

Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2009

iii. Installing the Q53
Connecting the Q53 to a Network

Use the RJ45 network connector, located on the side panel of the Q53 (see 

attaching to a 10/100Base-T (UTP) network. Plug a network cable into the network 
connector. If installing a Q53 without the Power Over Ethernet (POE) option, insert the 
three-prong power cable of the AC adapter into an AC outlet, and insert the barrel power 
connectors into the POWER connector on the side panel of the Q53; this will power on 
the device.

OFF

OFF

Normal operation. With both dipswitches in the "

OFF

" position, the unit 

will boot up using the settings in Flash rather than the default settings. 
Dipswitch 2 is in the "

OFF

" position from the factory so that the new settings 

that you store will be used.

ON

OFF

Factory default settings. With the dipswitches in this configuration, the 
unit will boot up and all settings stored in Flash will be erased except the 
Ethernet address and key value.

OFF

ON

Default IP (0.0.0.0). With the dipswitches in this configuration, the unit will 
boot with factory default settings, but the stored settings in Flash remain 
intact. This enables you to set an IP Address of your own. Setting dipswitch 
2 to "

ON

" will not clear any settings that you have stored in Flash. It simply 

boots the unit in a different state with the settings in Flash temporarily 
ignored.

ON

ON

Factory bootloader mode. Do not use this mode except as directed by 
Exegin technical support.