Legend Lifestyle Products Corp. T-00 Manual Do Utilizador
2
Control panel
1. Power ON / OFF button
2. Button for into torque or angle setting mode programming / increasing the setting values.
3. Switch for display mode(Peak or Track) / press and hold button for 2 seconds for selecting
2. Button for into torque or angle setting mode programming / increasing the setting values.
3. Switch for display mode(Peak or Track) / press and hold button for 2 seconds for selecting
units switch. / Under setting mode, press button to memorize the torque or angle setting
value.
value.
4. Button for pre-set torque and angle values to "0".
5. Switch into Torque or Angle measurement mode / Press button for 5 Sec. to display
5. Switch into Torque or Angle measurement mode / Press button for 5 Sec. to display
illumination / Under setting mode, the button is for selecting the next digit / Under Angle
measuring mode, the button is for decrease the value to program pre-set torque.
measuring mode, the button is for decrease the value to program pre-set torque.
Preparation for use:
·
Open the cover of the battery compartment by turning it count-clockwise.
· Insert four AAA batteries as shown below:
·
Close the battery compartment by turning the cover clockwise.
· The torque wrench is now ready for use.
Turning the tool on / off:
Turning the tool on / off:
· Press button to turn on. The buzzer sounds and on the display you can see all
readouts at the same time for just a moment.
· After 2-3 seconds, only the battery symbol, the value "0.0" and the units of measurement last
selected are displayed.
· Press button again in order to turn off the electronic system.
1
4
2
3
5