OCULII LLC VISDAR-RADAR Manual Do Utilizador
OCULII LLC
830 A Space Drive • Beavercreek , Ohio 45434
Phone: (937) 912-9261 • Email: info@oculii.com • Web: www.oculii.com
Step 1: Connect the single supply to dual supply adapter and the serial to USB adapter to the
component side of the module. The single supply to dual supply connector uses a three pin polarized
JST connector and plugs in on the lower center of the board and labeled “PWR”. The serial to USB
adapter plugs into a row of male headers on the lower right side of the module labeled “SERIAL”.
The black wire on the cable should be oriented downwards as seen in Figure 2.
component side of the module. The single supply to dual supply connector uses a three pin polarized
JST connector and plugs in on the lower center of the board and labeled “PWR”. The serial to USB
adapter plugs into a row of male headers on the lower right side of the module labeled “SERIAL”.
The black wire on the cable should be oriented downwards as seen in Figure 2.
Figure 2: Power supply and serial to USB adapter installation.
Step 2: Connect the other end of the serial to USB adapter into a source PC with the appropriate
USB to serial drivers. From a serial terminal on that PC (eg. hyperterminal, realterm) open the USB
to serial port to allow commands to be sent.
USB to serial drivers. From a serial terminal on that PC (eg. hyperterminal, realterm) open the USB
to serial port to allow commands to be sent.
8
Basic Setup Procedure: